Canbus system ballast
A new HID canceller ballast model which is much better than models canceller kit we made before, and canceller functions build inside the ballast. (include radio noise)

There are three problems when installing normal ballasts in some vehicles.
1) Headlights Keep flickering.
2) Lights go-off when turn on the lamp.
3) Headlights work ok, but warning light or error light appeared in the instrument board.
All above 3 problems will be ok when installing our
Canceller ballasts.
The advantage of our canceller ballast describes below:
1. This ballast can work with all 12v normal vehicles on hi beam or low beam
2. This ballast can work with BMW or Mercedes or Audi...etc,
People no need to worry about the solutions of the above 3 problems.
No need to use external resistor or relay...etc.

Input Voltage: 9V-16VDC
Operating Voltage: 13.2VDC (Typical)
Input Current: <3.2A DC (13.2VDC In)
Output power: 35W± 1W Constant Power
Output Frequency: 380Hz-400Hz
Output Voltage: 70V-140V AC True RMS Square Wave
Operating Temperature: -40° C~+105° C
Storage Temperature: -40° C~+105° C
Efficiency: > 83% With Input 13.2 v DC Condition

Protection:
Output open /short protection: Shutdown in 0.5 Sec End of life Lamp Voltage: 140v AC RMS Square Wave Waterproof

Dimension: L10.5* W 7 * H 3 (cm )